AUSTRALIAN POOL EQUIPMENT PRISTINE PRI-100 Panduan Pemilik - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penyedot Debu Kolam Renang AUSTRALIAN POOL EQUIPMENT PRISTINE PRI-100. AUSTRALIAN POOL EQUIPMENT PRISTINE PRI-100 12 halaman. Auto self cleaning

TROUBLE SHOOTING
The STATUS is displaying 'LOW SALT', what should I do?
The recommended salt level for the Pristine chlorinator to function properly
is 6000ppm. If your salt level is under this value or the water is extremely
cold, the chlorinator STATUS DISPLAY may indicate LOW SALT.
When adding salt to bring the level up to 6000ppm. ADD IT SLOWLY never
more than one bag at a time. Allow time for the salt to dissolve before adding
another bag.
Your local Pool Shop can test a sample of your pool water for salt levels.
The STATUS is displaying 'HIGH SALT", what should I do?
The maximum salt level for the Pristine chlorinator is 7200ppm. If your
salt level exceeds this, or if the water temperature is exceedingly high the
chlorinator STATUS DISPLAY may indicate HIGH SALT. If the salt level is
very high the chlorinator will cease operating momentarily and will attempt
operation at a lower power setting. This feature is especially helpful if you
are away, as the chlorinator will continue operation at a reduced output
rather than shutting down altogether.
HOWEVER: If you are alerted to the fact that the chlorinator is warning
HIGH SALT levels it is recommended that you switch off the chlorinator,
dump water from the pool and fill the pool with fresh water until the salt
levels are reduced to the optimum 6000ppm.
The STATUS DISPLAY constantly indicates 'PRIMING CELL'. What
should I do?
Check cell connection to the junction box on the rear of the control unit.
Check the filter pump is turned on and that water is flowing past the cell.
Check valves are open (if fitted).
Check water level of pool.
Check for skimmer box blockage.
Check for air in filter pump.
Check filter is clean.
The CHLORINE OUTPUT is LOW or NIL, what should I do?
Check that the chlorine output has not been turned down.
Check cell connection to junction box underneath control unit.
Check filter pump is working.
Check that the salt level is 6000ppm.
Check the water balance.
Page 17

INSTALLATION

Position the chlorinator power pack at least 1m above ground level and at least 2m from
the pool edge. Protect the unit from direct weather and sun. If supply cord is damaged, it
shall be replaced by the manufacturer or its service agent or similarly qualified person in
order to avoid a hazard.
The Pristine Cell must be fitted in the return to pool line after and above the filter and
should a pool heater be used the cell must be fitted after the heater. The Pristine Cell
can be positioned horizontally or vertically; however the preferred method is horizontally
(as illustrated).
The cell lead connects directly to the junction box on the back of the chlorinator power
pack. Make sure that the wires are colour matched correctly and that the connections are
tight.
The Pristine chlorinator must be connected to the correct supply voltage as indicated on
the rear of the unit. CAUTION : CHECK THIS VOLTAGE CAREFULLY
Add sufficient salt to give a salinity reading of 6000ppm (approximately 30kg of salt per
5000l). Start with less and test before you add additional salt.
INSTALLATION OVERVIEW
Page 6