austriamicrosystems AS5043 Panduan Pengoperasian - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Konverter Media austriamicrosystems AS5043. austriamicrosystems AS5043 12 halaman. 10-bit programmable magnetic rotary encoder adapter pcb operation manual
Halaman CetakAS5043 10-BIT PROGRAMMABLE MAGNETIC ROTARY ENCODER
Adapter PCB Operation Manual
If you use the Adapter PCB as external encoder for the AS5043 demoboard with an extension cable or experience
data transmission errors, it is requested to configure the Adapter PCB for 3.3V supply voltage.
9.1.1
Modifications to operate the adapter board at 3.3V
Perform the following modifications:
•
disconnect the 5V supply between Demoboard and Adapter PCB: remove or cut off pin "+5VUSB" at the
bottom of the AS5043 demoboard
•
connect pins "3V3" and "5V" on the Adapter PCB. Ideally, connect the pins right at the bottom of the
7pin female connector with a piece of wire or solder joint.
•
you may also remove the 78L05 voltage regulator from the Adapter PCB to prevent accidental damage
of the IC when an input voltage is applied to the regulator (and the 5V output is fed to the VDD3V3
supply pin)
Figure 9: Configuring the Adapter PCB for 3.3V operation (See Figure 10)
Figure 10: Connecting an external AS5043 application to the demoboard (See Figure 9)
* If longer cables are used, a pull-down resistor at the DO line of 22k - 56k Ohms is recommended to discharge
the signal between data transmissions and no static voltage is built up.
Revision A.02, 04. Jul 06
www.austriamicrosystems.com
Page 9 of 12