4T Medical AESTHETECH DUAL INJECTOR PRO+ Panduan Pengguna - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Medis 4T Medical AESTHETECH DUAL INJECTOR PRO+. 4T Medical AESTHETECH DUAL INJECTOR PRO+ 7 halaman. Radio frequency + electroporation + led unit
Halaman Cetak
3. Preparation before treatment
1. A consultation including examination of the skin.
2. Practitioner should wear gloves.
3. Remove any facial piercings.
4. Follow Step by Step instructions below.
4. How to use DUAL INJECTOR PRO+
1. Connect the Power cable (with transformer) and the Treatment handle to the machine.
2. Turn machine on using the POWER button on back of the machine.
3. The timer on the left hand side of the LED display is automatically set to 10 minutes. Using Up/
Down arrows adjust the time to 5 minutes.
4. Press Start button followed by Up/Down arrows to adjust the Radio Frequency intensity level shown
on the right hand side of the LED display to 5 (middle). Always check client comfort. The Radio
Frequency can be increased to 10 depending on comfort. The head of the probe appears RED. The
probe will only take 30 seconds to reach temperature.
5. Treat half the face for 5 minutes with (RF). Press STOP to turn off Radio Frequency. Alternatively it
will turn off automatically when the timer finishes. Repeat on the other side of the face.
6. ELECTROPORATION: Set timer to 5 minutes using Up/Down arrows.
7. Press silver dial down to turn on Electroporation. The head of the probe appears BLUE.
8. Use the silver dial to set the intensity, Min/Max according to the red light around the dial. Start
intensity half way. Always check client comfort
9. Treat one side of the face for 5 minutes, then repeat on opposite side of the face for a further 5
minutes.
10. Press Stop. Turn off the power on the back of the machine.
11. If machine is not in use, take the power plug out of power supply.
To clean the Treatment handle after treatment, use an antibacterial solution or wipe (avoiding alcohol
based products) to wipe off any impurities, and then use disinfecting solution.
4.1. Cleaning and maintenance
1. Before cleaning turn off the machine and take the power plug out of power supply.
2. Machine, cables and treatment handle should be cleaned carefully using a product such as
Globaquat Alcohol Free wipes (avoid alcohol based products).
3. Before and after each treatment all parts which have been in contact with the patient's skin must be
disinfected.
!!! WARNING !!!
All cleaning and maintenance operations should be carried out with extreme caution (with disposable
gloves.) Dirt, bacteria and other germs can cause severe infections.
Dual Injector Pro+ User Manual (Ver. 1-2017)
Page 5