Austro Flamm KOKO 2.0 Petunjuk Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Kompor kayu Austro Flamm KOKO 2.0. Austro Flamm KOKO 2.0 20 halaman.

Halaman Cetak

english

Floor load capacity

Make sure that the load capacity of the supporting

construction is sufficient to carry the weight of the

, before the heating unit is installed.

entire unit

Combustion air

Being the user of the stove you must take care of a

sufficient combustion air supply. Sealed-up windows

and doors may not allow a sufficient combustion air

supply or disturb the draught behaviour of your stove.

Please ensure the additional supply of fresh

3. CORRECT OPERATION OF YOUR STOVE

Approved fuels

Dry, well cured and natural wood (hardwood

preferred), wood briquettes.

Maximum amount of fuel

Maximum amount of fuel to be added: 1,3 kg wood

or 1 kg wood briquettes. Larger amounts of fuel

can lead to overheating and thus damage the

stove.

Clean burning

The wood must be dry (relative wood moisture

< 15%) and untreated and the right amount of wood

must be burned in order to ensure a clean fire that

releases only small amounts of emissions.

Making a fire

For the correct and safe operation of your stove

please pay attention of the chimney developing the

necessary feed pressure. This must especially be

considered before the initial operation (or e.g. after

the summer heating break) and during the mid-

season heating periods (e.g. at strong wind, etc.).

If there is not enough feed pressure, please light only

some paper or small kindling first, in order to "warm

up" the stove and the chimney.

Fully pull out both levers for the combustion air and

the grate (position "AUF" fig. 2, also fig. 4).

Place 2-3 logs (approx. 1,0 kg in total) crossways in

the combustion chamber with sufficient distance from

each other (min. 2 cm), on top of that place some

softwood chippings (0,3 kg) and some ignition aid and

light.

Close the door!

We recommend to let the first load burn down without

changing the air lever position.

combustion air if necessary. For details please

consult your specialist retailer

Stove pipe connection

For your own safety stringent laws apply for

connecting the stove pipes to the chimney. Your

professional dealer or distributor knows these laws.

Please have your certified retailer carry out the

connection of your stove

Fig. 3: before lighting

As soon as no visible flames are left (only embers in

the combustion chamber), you can put another load

of logs (max. 1,3 kg) in the combustion chamber if

desired.

When reloading the stove please repeat the

procedure as mentioned under "first lighting": air lever

position on "AUF" (= open), open door carefully, place

logs, close door.

After a few minutes, when the logs burn well on all

sides (bright, high flames), you can adjust the heat

output with the air lever (lever on max. position "AUF"

= maximum heat output), the flames should be yellow

and never look blueish or have black tips (otherwise

add more air) – see fig. 4. Never close air supply

completely during operation.

Fig. 4: adjust air lever

The grate does not have to be operated during

operation. It is only used for moving ashes from the

combustion chamber to the ash box, when stove is

not in operation.

Koko 2.0