BENDIX Wingman FLR10 Panduan Petunjuk Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Aksesori Mobil BENDIX Wingman FLR10. BENDIX Wingman FLR10 8 halaman. Radar changeover kits

Halaman Cetak

LateRaL aLIGnment usInG tHe BendIx

Locate symmetrical points on the front of the vehicle that are at least 12 inches from the vehicle's center line (such as

the tow hooks). Using a ruler or tape measure, record the distance from each side to the laser light line.

note: The technician must be careful during the laser positioning process to double-check the values measured on each

side of the truck. Be sure to check back and forth for each side of the radar sensor several times to ensure accuracy.

Repeat the process for the opposite side, reversing the tool, so that the laser light points to the other side of the

vehicle.

Compare the left and right distance measurements. A properly aligned radar sensor will have the same measurement

from each side. If these two dimensions are within 1/8" (3 mm), no alignment is necessary and the technician can

go to Step A10 to check the vertical alignment. If an adjustment is needed, follow the instructions in A7-9.

appendix

Bendix

FLR20

aLIGnment tooL (ContInued)

lateral alignment leFt measurement

The Whole

Tool is

Reversed for

the Second

Measurement

Laser

Light Beam

™

Radar alignment

Lateral Alignment

Laser