BENDIX Wingman FLR20 Panduan Petunjuk Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Aksesori Mobil BENDIX Wingman FLR20. BENDIX Wingman FLR20 8 halaman. Radar changeover kits

Halaman Cetak

LateRaL aLIGnment usInG tHe BendIx

NOTE: Complete these steps only if a lateral adjustment is necessary.

With the Bendix alignment tool still in place, use the Torx T-20 screwdriver to turn by hand the driver-side stand-off

adjustment screw until the desired alignment is reached.

Re-measure the distances from symmetrical points located at least 12" from the center line of the vehicle. Reverse

the tool for each measurement, until the values are the same [within 1/8" (3 mm)].

After the lateral alignment procedure is complete, if there is an active misalignment DTC (codes 55, 56, or 57), use

the instructions in Bendix Service Data Sheet, SD-61-4960 (available from www.bendix.com) to clear the Bendix

Wingman

Advanced

Diagnostic Trouble Codes (DTCs) and reset the alignment value by connecting the vehicle to a PC with Bendix

ACom

Diagnostics software and follow steps B4.4-20 to reset the alignment value.

of the Service Data Sheet.)

A10

ImPoRtant: Before returning the vehicle to service, check the vertical alignment.

A11

[The steel clip, or plate, and alignment tool should already be in place. See A1-2.]

A12

Calibrate (or "zero") the inclinometer on a horizontal section of the frame rail. Follow the manufacturer's instructions

(typically digital inclinometers have a "SET" button for this purpose).

NOTE: Complete these steps only if a vertical adjustment is necessary.

A13

With the Bendix alignment tool still in place, use the screwdriver to turn

by hand the top-left adjustment stand-off. See the Figure on the right.

During the adjustment, observe the digital display on the inclinometer

and turn the vertical alignment screw clockwise or counterclockwise

depending on the vertical direction (up or down) needed, until the

reading is near zero degrees.

A14

the radar is aligned vertically when the display is near zero (0°).

Note: The alignment process shown here is for Bendix alignment

brackets. For other brackets, similar alignment steps will be needed;

consult the vehicle manual for full instructions.

note: the alignment process is complete after the vertical alignment has been checked (and adjusted, if

necessary), and the steel clip or plate is removed. you do not need to test-drive the vehicle.

Bendix

FLR20

system's Diagnostic Trouble Code (DTC) using the procedure in Section 4.4: Clearing

™

Calibrate (or "zero") the Digital Inclinometer on a

Cab Frame Rail in the direction that the vehicle

travels.

Place the calibrated digital inclinometer onto the

surface of the tool, so that the tool is in the

same direction as it was on the rail. Verify

that the display shows 0° (± 1.5°) from vertical.

appendix

™

Radar alignment

aLIGnment tooL (ContInued)

ImPoRtant:

do not adjust

Use a Torx T-20 screwdriver here to

this stand-off!!

adjust for the lateral alignment

(Also, see Appendix H

Use a Torx T-20 screwdriver here to

adjust for the vertical alignment

ImPoRtant:

do not adjust

this stand-off!!