Airwell RC7 Buku Petunjuk - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Kontrol Jarak Jauh Airwell RC7. Airwell RC7 10 halaman.

Halaman Cetak

OPERATION

AUTOMATIC OPERATION

1. Set the MODE selector to AUTO

2. Press the ON/OFF button and switch the air

condioner ON.

3. Press the TEMP. buttons to set the desired

temperature (the temperature range is

between 30 °C max. and 16 °C min.).

THE DISPLAY SHOWS THE

SELECTED TEMPERATURE.

W h e n t h i s s e t t i n g i s s e l e c t e d , t h e a i r

c o n d i t i o n e r c a l c u l a t e s t h e d i f f e r e n c e

between the thermostat setting and the room

temperature and automatically switches to the

COOL or HEAT mode as appropriate.

4. Switch the FAN SPEED selector button to the

setting you want.

Example of operation diagram in the

(Auto) mode with the set room temperature at

23°C.

NOTE

The air conditioner changes the operation

mode (from cool to heat), if one of the

following conditions occurs:

- ZONE A: changes if the difference between

the room temperature and the temperature

set on the remote control unit is at least 3°C..

- ZONE B: changes if the difference between

the room temperature and the temperature

set on the remote control unit is at least 1°C,

one hour after the compressor stop.

- ZONE C: never changes if the difference

between the room temperature and the

temperature set on the remote control unit is

no more than 1°C.

DEHUMIDIFYING (DRY)

1. Set the MODE selector switch to "DRY"

2. Press the ON/OFF button and switch the air

condioner ON.

3. Press the TEMP. buttons to set the desired

temperature (the temperature range is

between 30 °C max. and 16 °C min.).

NOTE

Use DRY operation when you want to

reduce the humidity in the room.

Once the room temperature reaches the set

level, the unit repeats the cycle of turning

on and off automatically.

During DRY operation, the fan speed is

automatically set to low or stops to prevent

overcooling.

Dry operation is not possible if the indoor

temperature is 15 °C or less.

FAN ONLY

If you want to make air circulate without any

temperature control, follow these steps:

1. Set the MODE selector switch to "FAN"

2. Press the ON/OFF button and switch the air

conditioner ON.

THE DISPLAY SHOWS THE

SELECTED TEMPERATURE.