dymax ACCU-CAL 160 Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Alat Ukur dymax ACCU-CAL 160. dymax ACCU-CAL 160 19 halaman. Radiometer

ACCU-CAL™ 160 Radiometer User Guide

The device's internal temperature during calibration and measurement is recorded. With this

information, the temperature dependency is automatically corrected within the device.

Environmental Considerations

Radiometers are sensitive to extremes in environmental conditions like high temperature,

humidity, and contamination. Protect the device and its detector(s) from high humidity, high

temperature, direct sunlight, and contamination.

■

Do not use the ACCU-CAL™ 160 immediately after moving it from a cold to a warm

environment. Under certain circumstances, condensation could arise and negatively

impact the electrical and optical functions. Allow the radiometer to adjust to the

temperature of the surroundings before switching it on.

■

Do not use the ACCU-CAL™ 160 in powerful magnetic, electromagnetic, and electrostatic

fields. These disturbances may influence measurement results.

■

Do not expose the ACCU-CAL™ 160 to temperatures exceeding 60°C (140°F) during an

exposure run. Exposure to temperatures exceeding 80°C will cause unit failure and will

void the warranty.

Setup & Operation

Turning on the radiometer: Press and hold the On/Off Button until the Display Window

illuminates. The Display Window will briefly show the radiometer model name, serial number,

software version, date of calibration, range, and wavelength band installed. Continuing to

press the On/Off Button at startup will display the startup information until the button is

released. The Display Window will then enter the default mode and show the data from the

last run before the unit was turned off.

Turning off the radiometer: Press and hold the On/Off Button for approximately two seconds.

The Display Window will indicate that the unit is shutting down and eventually turn off.

Turn backlight illumination on/off: Quickly press the On/Off Button.