4xem IPCAMENCLOHF Petunjuk Pemasangan - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Pemasangan untuk Aksesori Kamera 4xem IPCAMENCLOHF. 4xem IPCAMENCLOHF 4 halaman. Camera enclosure

Fitting Instructions for Camera

1. Unscrew the 4 captive Retaining Screws (C) and remove the Housing Cover (A)

from the Housing Base (B).

2. Release the 4 Keyhole Screws (F) and then slide and withdraw the Camera

Platform (G) from the Housing Base (B).

3. Mount the Camera (H) onto Platform (G) using the ¼" UNC Screw (I) supplied,

ensuring that the Installation Pad (J) is mounted between the Platform and the

Camera. Always ensure that the Camera is firmly attached to the Platform.

4. Connect the Camera/Heater power cable to the rear Terminal Block (E) through

the first Cable Conduit (D) referring to the circuit diagram shown in the section

tilted "Proper Wiring" for proper terminal designations.

5. Connect the video cable to the Camera through the second Cable Conduit (D).

Fig. 3 – Fitting Instructions for Camera Continued

IMPORTANT NOTE:

ALWAYS UNPLUG THE TOP SECTION OF THE GROUND WIRE

(EARTH WIRE) FROM THE BASE WHEN DISASSEMBLING THE HOUSING.

REMEMBER TO PLUG THE TOP AND BOTTOM TOGETHER AGAIN WHEN

REASSENBLING THE HOUSING.