dymax 110 Panduan Pengguna - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Unit Kontrol dymax 110. dymax 110 20 halaman. Spray valves

Halaman Cetak
14
Dymax Model 110 & 210 Spray Valves User Guide

Assembly Instructions

Refer to Figure 1 for part reference designation.
General
■
All O-Rings must be lubricated with a small amount of silicone grease.
■
A small amount of removable thread locker should be applied to the Set Screw (U)
and the male threads of the Standoffs (G).
■
Assemble the air section (M,I) and fluid section (D) separately prior to connecting
the assemblies.
Air Section
1.
Assemble the Stroke Adjuster (O) and Lock Nut (N) with the hex head toward the
knurled end of the bolt.
2.
Mount one 008 Buna O-Ring (L) on the inside groove of the Stroke adjuster (O).
3.
Assemble the Stroke Adjuster (O) assembly into the Upper Air Body (M).
4.
Mount one 014 Buna O-Ring (J) on the end of the Upper Air Body (M) and the other
008 Buna O-Ring (L) on the end groove of the Stroke Adjuster (O).
5.
Back out the Stroke Adjuster (O) by turning it counter-clockwise to the end of its
travel.
6.
Drop the Needle (C) into the Piston (K) and assemble with the Set Screw (U) using
an adjustable wrench and 5/64" Allen key to tighten.
7.
Mount the 014 Buna O-Ring (J) onto the Piston (K).
8.
Apply a small amount of silicone grease to the inside of the Lower Air Body (I) then
drop in the Piston (K) and Needle (C) assembly.
9.
Mount the 004 Buna O-Ring (S) on the end of the Needle (C) and slide it down into
the groove in the end of the Lower Air Body (I).
10. Slide the End Cap (H) onto the Needle (C) up to the Lower Air Body (I), place the
Spring (T) on top of the Piston (K), and assemble the two air bodies using two
Machine Screws (P) tightening with a 3/32" Allen key.