GABOR FSM-S Panduan Pengguna - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Rak dan Dudukan GABOR FSM-S. GABOR FSM-S 16 halaman. Mount for small flat-panel displays
Halaman Cetak
Attaching the Wall Bracket to Wooden Studs
Wooden studs run vertically inside the wall, 16 inches apart, behind the drywall or plaster.
The wall bracket must be mounted to a wooden stud, or the bracket could fall out and
damage your display or cause personal harm.
Drywall
X
1.
Use a stud finder to locate the edges of
the wooden stud, and mark the center.
X
X
X
2.
Place the wall bracket template up to the
marked locations and tape it to the wall.
Use the included bubble level to make
sure the template is level before drilling.
Use a pencil to mark the three drilling
holes for the anchor screws and then
apply a piece of tape over the marks.
H
J
K
L
N
O
3X
3X
1X
2X
1X
1X
3/16 in.
2.2 in.
3.
Use a 3/16-inch (4.5 mm) wood drill bit
to predrill the marked spots 2.2 inches
(55 mm) deep, and then clean out the
debris from the holes. Remove the
template from the wall.
9