GABOR TM-SS Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Rak dan Dudukan GABOR TM-SS. GABOR TM-SS 12 halaman. Tilting wall mount for small flat-panel displays

Halaman Cetak

Attaching the Wall Bracket to Wooden Studs

Wooden studs run vertically inside the wall, 16 inches apart, behind the drywall or plaster.

The wall bracket must be mounted to a wooden stud, or the bracket could fall out and

damage your display or cause personal harm. Four anchor screws (I) have been included

for use with the TM-SS, but you will need only two screws.

Use a stud finder to locate the edges of the wooden studs, and mark the center of each stud.

Place the wall bracket up to the marked locations, and use a pencil to mark drilling holes for the anchor screws. Use the

included bubble level to make sure the bracket is level before drilling.

Use a 3/16-inch (4.5 mm) wood drill bit to predrill the marked spots 2.2 inches (55 mm) deep, and then clean out the

debris from the holes.

Attach the bracket to the wall by inserting the two anchor screws through the washers and the wall brackets' mounting

holes, and screw them into the predrilled support holes until secure. Use the wrench to further tighten the anchor

screws, but do not overtighten. Use the included bubble level to make sure the bracket is level.

TM-SS / TILTING

WALL MOUNT

/ SMALL

2.2 in.

Drywall

3/16-inch