AFF 3102A Buku Petunjuk - Halaman 3

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Jacks AFF 3102A. AFF 3102A 12 halaman. 1 ton 2 stage transmission jack

ASSEMBLY

1. Refer to the parts diagrams and parts listing in the manual for identification, location, and position of parts.

2. Take out all parts from the box and lay on a flat surface.

3. Secure caster with foot brake (53) and regular caster (6) onto the leg base (48) by using nut (50,) lock

washer (51,) and washer (52.) Secure the other 2 casters on the opposite leg base using the same

hardware.

4. Place the hydraulic pump (36) in an upright position. Secure the legs (48) to the pump by using washer

(54,) lock washer (55,) and bolt (56.)

5. Attach the adjusted support rod (24) to support ring (19) by using bolt (21,) lock washer (22,) and nut (23)

and make the upper end of support ring (19) close to the lower end of nut (25.) (see Figure 1.)

6. Adjust the length of round nut base (17) and bolt (26) to make the hole of bolt (26) align to the hole of the

leg (see Figure 2.)

7. Fix the adjusted support rod (24) to the leg (48) by using lock washer (22,) nut (23,) and bolt (49) and

tighten the round nut base (17.) Finally tighten bolt (20) to oil tank (27) cross support ring (19.)

8. To assemble the saddle (57) first loosen and remove bolt (S19) and place saddle on the second piston rod

(7.) Tighten bolt (S19) to secure.

Figure 1

Page 3

Figure 2