Dymo LabelWriter 4XL Label Printer Panduan Memulai Cepat - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Printer Dymo LabelWriter 4XL Label Printer. Dymo LabelWriter 4XL Label Printer 9 halaman. Labelwriter series label printers
Juga untuk Dymo LabelWriter 4XL Label Printer: Panduan Pengguna (20 halaman), Spesifikasi (2 halaman), Ikhtisar (2 halaman), Panduan Pengguna (19 halaman)
Halaman Cetak
NOTE: For Windows, do not connect the printer
to your computer until instructed to do so
during the software installation.
TO CONNECT THE POWER
1.
Plug the power
cord into the power
adapter.
(See Figure 2)
2. Plug the power
adapter into the
power connector
on the bottom of the
printer. (See Figure 3)
3. Plug the other end
of the power cord
into a power outlet.
TO LOAD A LABEL ROLL
NOTE: Each label roll comes in a black plastic
bag. Store the label roll in the bag when the
labels are not in use.
1.
With the printer plugged in, press the form-feed
button to eject the labels that protected the printer
during shipment.
2. Open the top cover and remove any packing
material inside the label compartment.
3. Remove the label spool from inside the cover and
separate the spool guide from the spindle.
4. Hold the spool
spindle in your left
hand and place
the label roll on
the spindle so that
the labels feed
from underneath
and the left edge
of the label roll is
firmly against the side of the spool. (See Figure 5)
5. Slide the spool guide onto the right side of the spool
and press the guide tightly against the side of the
label roll, leaving no gap between the roll and the
spool.
PAGE 2 OF 9
CONNECTING THE PRINTER
Figure 2
Power Adapter
Power Cord
Power
Figure 3
Connector
USB Port
USB
24VDC
Cable
Channel
LOADING LABELS
Figure 5
Spool
Spool
Spindle
Guide
4. Plug the USB cable
into the USB port on
the bottom of the
printer. (See Figure 3)
5. Insert the power and
USB cables through
the cable channel
and set the printer down. (See Figure 4)
NOTE: DO NOT CONNECT the other end of the
USB cable to your computer until asked to do
so during the software installation.
6. Connect the printer to your computer as follows:
a. For Windows: plug the USB cable into a USB
port ONLY when prompted during the software
installation.
b. For Mac OS X: plug the USB cable into a USB port
prior to installing the software.
NOTE: To ensure proper feeding of labels
during printing, label roll must fit snugly against
both sides of the label spool, with no gaps.
6. Insert the label
spool into the slot
in the printer cover
with the labels
extending from
underneath the roll.
(See Figure 6)
7. Align the left edge
of the label with
the left edge of the
label feed slot and
insert the label into
the slot. (See Figure 7)
The printer feeds the
labels, stopping at the
beginning of the first label. If the printer does not feed
the labels, make sure the first label is fully inserted and
then press the form-feed button.
NOTE: Regardless of the label width, the left
edge of the label must be aligned with the
left edge of the label feed slot for the labels to
feed properly.
8. Lower the top cover.
Figure 4
USB Port
Figure 6
Align label with left
edge of label path
Figure 7
0719 IH-2788