Dyna SD 60 Panduan Operator - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Operator untuk Pemotong Dyna SD 60. Dyna SD 60 9 halaman. Tenon cutter

If the feed speed is too fast or too slow, the speed can be adjusted

by turning the screwdriver flow controls on the cylinder. See Fig.4.

If the log chatters your clamp may be set light or you may be

feeding too slowly into the cutter head. If you increase the clamp

pressure too much you damage the log surface, however do not

sacrifice safety for beauty by decreasing the clamp pressure below

60PSI.

VARI-A-CUT TENON CUTTER

Cutter head can be used as a fixed style cutter or the tenon size can be

adjusted by replacing the aluminum sleeve and the knives with the correct

sized insert kit. The sleeve can be adjusted or replaced by loosening the set

screw on the side of the cutter head.

The most practical method for adjusting the knives is to insert a tenoned

piece and setting the knives against it. If the cutter is too aggressive, then set

the knives out. If the wood tenons too slowly, then set the knives in or

resharpen them.

The cutter should throw nice shavings. If it begins throwing sawdust then

the knives are likely dull.

The operator must keep all body parts away from the cutter at all times.

The cutter should not be turning faster than 1200 RPM.

Fig. 4

Speed Adjustment