DAW Industries TGK-4P10 Manual - Halaman 5

Jelajahi secara online atau unduh pdf Manual untuk Peralatan Medis DAW Industries TGK-4P10. DAW Industries TGK-4P10 10 halaman.

Halaman Cetak

Patient Notes

DAW

Industries

For Technical Support call (800)242-8669

True-KD

Wire Basket Adapter (TSC-BX)

The Lo-Pro Rotator attaches directly to the top of any DAW

True-KD

Series knee . It's low build height allows KD Amputees

™

the convenience of knee rotation while still maintaining cosmetic

appearance in the sitting position .

The Lo-Pro Rotator features an

Unthreaded Side (with an unthreaded 4-Hole pattern) and a

Threaded Side (with a threaded 4-Hole pattern*Rubber Plug) .

Threaded Side

Rubber Plug

Connection of the Lo-Pro Rotator to the 4P10 KD

After lamination of the Wire Basket Adapter (TSC-BX) is complete,

A. First, screw in the included M4 Screw

(by hand) partially into the Rubber Plug

and pull up to remove it .

B. Push and hold down the Button and rotate

until the Plug's Hole lines up with one of

the unthreaded holes on the rotator's other

side . If it is difficult to rotate, screw in 2

M6 Button Head Screws partially into the

Threaded Side to use as leverage .

C. With the Unthreaded Side against the

adapter, insert one of the included

M6 Button Head Screws (4mm hex)

through the 2 holes into a threaded hole

of the Wire Basket . Screw in, but do not

tighten . It's recommended the button be

positioned facing forward .

D. Repeat steps B . & C . until all 4 M6 Button

Head Screws are screwed in . Torque each

screw to 7.4ft-lb (9.9Nm) .

E. Return the Rubber Plug to its hole .

F. Now you may secure the knee to the bottom of the Lo-Pro

Rotator using the included

bolt to 9ft-lb (12.2Nm) .

DAW

Industries

Series Knee Connection to

™

with Lo-Pro Rotator

Unthreaded Side

™

Screw

Button

M6 Buttonhead

Screw (4mm hex)

Bolt (8mm hex) . Torque the

Lock Washer

For Technical Support call (800)242-8669

™

Rubber

Plug

Bolt

(8mm hex)