Gage Bilt GB110A/2-4AH Manual Petunjuk Asli - Halaman 10

Jelajahi secara online atau unduh pdf Manual Petunjuk Asli untuk Peralatan Gage Bilt GB110A/2-4AH. Gage Bilt GB110A/2-4AH 17 halaman. 20v battery installation tool

Halaman Cetak

Additional Actuator Assembly (VP1316) functions:

Note: The installation tool has two additional functions that are controlled with the actuator assembly (VP1316).

Service position: Press the actuator assembly (VP1316) for five seconds (until the white LED on the tool starts to flash (1 /sec)

and release again. The installation tool remains in the rearmost position. The anvil insert can now be easily changed or the

clamping jaws serviced. Press the actuator assembly (VP1316) briefly and the tool moves to its starting position again.

Auto and Manual mode:

a. In Manual mode, hold the actuator assembly (VP1316), depressing during setting of the fastener until the mandrel is sheared off.

b. In Auto mode, you only have to press the actuator assembly (VP1316) briefly and the installation tool controls the fastening

process automatically.

To change from one mode to the other, hold the actuator assembly (VP1316) pressed for ten seconds (until the white LED on the tool

starts to flash (2 sec.) and release again. Press the actuator assembly (VP1316) briefly and the tool moves to its starting position again.

Attaching the Belt Clip (VP1322):

Note: Always ensure belt clip (VP1322) is secure to the installation tool before using.

Attach the belt clip (VP1322) to the foot of the installation tool using the screw. A corresponding thread and slots are recessed in the foot

of the housing on both sides of the installation tool.

Check at regular intervals that the belt clip (VP1322) is still securely attached. Otherwise, retighten the screw.

SLOTS FOR BELT CLIP (VP1322) (2X)

BELT CLIP (VP1322)

Battery (VP1086/VP1357) Storage:

Protect the battery (VP1086/VP1357) from moisture and liquids. Do not leave in car e.g. in the summer.

Store the battery (VP1086/VP1357) only in optimum temperature range between -22°F (-30°C) and 77°F (25°C). The batteries can be

stored as follows without recharging:

Storage period between 22°F (-30°C) and 77°F (25°C) = 1.5 years

Storage period between 22°F (-30°C) and 113°F (45°C) = 3 months

Storage period between 22°F (-30°C) and 140°F (60°C) = 1 month

A significantly shorter operating time after recharging indicates that the battery (VP1086/VP1357) is worn out and needs to be replaced.

Observe all local disposal procedures.

GB110A 20V BATTERY INSTALLATION TOOL

HOW TO SET-UP THE GB110A Cont.

SCREW

8/18 REV 8/22