Gage Bilt GB574 Manual Petunjuk Asli - Halaman 7

Jelajahi secara online atau unduh pdf Manual Petunjuk Asli untuk Peralatan Gage Bilt GB574. Gage Bilt GB574 16 halaman. Installation tool

After the tool is connected to a suitable hydraulic power source that is set at the correct recommended pressures and the correct nose

assembly is attached to the installation tool, the fastener is then inserted into the nose assembly. Pressing the actuator starts the hydraulic

power source. Hydraulic oil is then directed to the rear of the head piston starting it to move forward. The internal parts on the nose

assembly are also moving forward thus starting the installation process. As the nose assembly encounters resistance from the fastener,

the hydraulic pressure builds until the tool reaches its full forward preset position. After maximum pressure is met, the actuator is then

released, thus allowing the hydraulic pressure to drop and allowing the spring pressure in the front of the piston to return the piston

and the nose assembly to their start position.

GB574/GB574A Installation Tool

PRINCIPLE OF OPERATION

HYDRAULIC DIAGRAM

PULL Cycle

Piston Travel

PULL Pressure

Images may not reflect actual tool

Pressurized Oil

Unpressurized Oil

RETURN Cycle

Piston Travel

RETURN Pressure

Rev. 6/22