Gage Bilt GB713 Manual Petunjuk Asli - Halaman 12

Jelajahi secara online atau unduh pdf Manual Petunjuk Asli untuk Alat Listrik Gage Bilt GB713. Gage Bilt GB713 20 halaman.
Juga untuk Gage Bilt GB713: Panduan Instalasi (14 halaman), Manual Petunjuk Asli (18 halaman)

Halaman Cetak
Gage Bilt GB713 Manual Petunjuk Asli
Providing all maintenance conditions have been met, follow this systematic approach to diagnosis.
1. MORE THAN ONE PULL IS REQUIRED TO BREAK FASTENER.
a)
Tool needs to be bled. (See filling and bleeding procedure pg. 11).
b)
Spring has fatigued, replace.
c)
Jaws are stripped or packed with chips. Clean or replace.
d)
Incorrect nose tip.
2. SLOW OR PARTIAL OPERATION WHEN THE ACTUATOR LEVER ASSEMBLY (704343) IS DEPRESSED.
a)
Polyseal (A-1119) and o'ring (400793) on the piston (713211) could be worn or damaged. Replace.
b)
Back-up ring (S908) and o'ring (A-201) on the piston rod assembly (744136) could be worn or damaged. Replace.
c)
Muffler (744143) or filter inside valve spool assembly (743142) may be plugged with dirt. Clean thoroughly and back-
blow with compressed air.
d)
Hole in metering screw in valve spool assembly (743142) may be blocked or damaged. Hole diameter should be .028" (.71 mm).
Clear and size or replace.
3. NO OPERATION WHEN ACTUATOR LEVER ASSEMBLY (704343) IS DEPRESSED.
a)
Tool seized due to mechanical failure or damaged parts.
4. OIL LEAKAGE.
a)
DO NOT
OPERATE WITH OIL LEAKING FROM TOOL. HIGH PRESSURE OIL MAY CAUSE SEVERE PERSONAL INJURY.
b)
Any oil leaking externally should be traced to its source. An o'ring or seal that leaks should be replaced.
5. AIR BYPASS FROM VALVE HOUSING.
a)
If the spring (744144) breaks or dislodges, air will flow freely through the muffler (744143). Replace or reset. Valve
spring installation tool (744251) is recommended.
b)
Check o'rings on valve sleeve (743144), valve spool assembly (743142), and valve plug (744142). If worn or damaged,
replace. Valve sleeve removal tool (744152) is recommended.
6. FASTENER STEM JAMMED IN NOSE ASSEMBLY.
a)
Nose assembly components require service.
disassemble. Replace worn or broken parts. Clean the surface the jaws ride on.
b)
Stems lodged side by side in the follower. Disassemble, remove stems, and reassemble.
c)
Incorrect follower.
GB713 Installation Tool

TROUBLESHOOTING

DISCONNECT AIR FROM

STROKE LIMITER INSTRUCTIONS

1.
Disconnect air from tool.
2.
Remove end cap.
3.
Slide Stroke Limiter over rear Piston. (See Nose Assembly
Selection Chart pg. 18 to select Stroke Limiter)
4.
Tighten End Cap onto tool. (See pg. 10 for torque setting)
Images may not reflect actual tool
12
TOOL, remove the nose from the tool and
STROKE LIMITER
7/11 REV 5/22