Hi Sharp 3.5" Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Monitor Hi Sharp 3.5". Hi Sharp 3.5" 8 halaman. 3.5” lcd cctv test monitor

Fundamental illustration

1. Language："Menu key"à"Down key"àLanguage； There have English, Français,

Deutsch, Italiano, ,Español, 日本語, Chinese language to select.

2. LCD panel color adjust： Click "Menu key" to entry adjust OSD menu as below.

2. Battery status：Display on the right-up of screen to show battery residual capacity. The

full level estimates 6 hours usage, the least level could provide 5 minutes to record

important data and ready to turn off.

3. Charge method：System indicator will show charge status. Charge independently is

better for battery life and fast short battery charger time.

4. Calibrate method：Adjust the Brightness value to 30 in Menu page then press the "Right

key + MODE key" to entry the calibrate mode. The default value is 128 and user could

adjust 0~250 to decrease or increase ratio from 0~2 times of measurement value. The

adjust measurement parameters include Video level, AC and DC voltage and this

coordinate setup will retention forever until your next setting modification.

Notice：When you first time to start using the test monitor, please charge battery

above 5 hours to make sure this battery is fully charge to extend its usage life as

your cell phone. After that the battery just charge 2~3 hours could be charged fully

and enough usage for 5~6 hours. Battery charge life time about 250 times and

depend on use environment and operation to decide its decadent speed. Please

follow correct charge method to extend battery life.

Caution：Although test monitor could work and charge at the same time,

but must do not measure AC voltage when battery in charger mode, it

will cause explosive accident!

"Sleep Time" means sleep mode timer setting when

user no use test monitor that system will turn off

power automatically.