Dawnway UVC100 Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Produk Pipa Dawnway UVC100. Dawnway UVC100 6 halaman. Uv-c led disinfection faucet, sgs test-approved disinfection rate 99.9%

Halaman Cetak

Installation Steps (Please refer to Fig. 3, Fig. 4)

1. Ensure a ∮35mm mounting hole in the countertop.

2. do not remove or loosen the lock nut (8).

3. Ensure that the waterproof O-ring (7) is attached to the base plate

of the faucet, remove the horseshoe gasket (2) and set it aside,

and leave the rest of the parts on faucet .

4. Install faucet with the inlet threaded tube (1), water flow switch

(5) and power cable(4) through the mounting hole(∮35mm ) in

the countertop.

5. Place the horseshoe gasket (2) under the countertop (9) between

the hex lock nut (3) and countertop(9) and then tighten the hex

lock nut (3) . (Please make sure that the power cable (4) must

pass through the gap of the horseshoe gasket (2), otherwise the

power cable will be damaged and thereby cause damage to the

UVC module.)

6. Please prepare a 1/4" PE pipe of suitable length, and connect it to

the water flow switch (5) and the water supply connector.

Lock Nut(8)

Inlet Threaded Tube(1)

Horseshoe Gasket(2)

Hex Lock Nut(3)

Power Cable(4)

Black Socket(4-1)

connects to

power supply

Water Flow Switch(5)

Arrow Tip(5-2)

points upward

Green Plug(5-1)

Of Power Cable

Green Socket(4-2)

connects to

flow switch

Black

Plug(6)

connects to

water supply

( Fig. 3 )