Active Silicon FireBird Panduan Memulai Cepat - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Perangkat Keras Komputer Active Silicon FireBird. Active Silicon FireBird 12 halaman. Frame grabbers
Juga untuk Active Silicon FireBird: Panduan Memulai Cepat (12 halaman)
Halaman Cetak
GENTL CAMERA LINK SETUP UTILITY
The GenTL CL Setup Utility needs to
be run to allow the use of Camera Link
cameras that support GenICam. It
is needed because Camera Link pre-
dates GenICam so cameras cannot be
discovered automatically.
The utility only needs to be run once
for a given camera connection. To
Use Camera Probing to select a channel on
a FireBird board, and the camera that is
connected to it.
The list of cameras will show all the CLProtocol
DLLs installed on the machine, including the
generic GenICam#GenCP_01_00 DLL which
should be used for all GenCP cameras.
Click Add to attempt to connect to the camera.
If it is found it will be added to the list of
known cameras.
The Status Log shows what the
utility has done.
FireBird Frame Grabbers – Quickstart Guide v2.4
do this run it from the Tools menu in
ActiveCapture, after ensuring that no
cameras are open in ActiveCapture, and
closing any other application that may
have the cameras open.
After it has been run, refresh the Device
List in the GenTL consumer application
in use, such as ActiveCapure, and the
camera should then be listed and
operate correctly.
The utility associates a CLProtocol DLL
with a specific Camera Link port on
FireBird. For cameras using GenCP, a
generic GenCP DLL is provided as part of
the FireBird installation.
For other cameras, note that only
Camera Link cameras that are provided
with a CLProtocol DLL can be used with
GenICam. Older Camera Link cameras
may not provide a suitable DLL and
therefore will not work with GenICam
applications. Contact the camera vendor
to obtain the correct DLL file.
This list shows all the cameras that have been
found and added using the Camera Probing
controls.
Click Save when the cameras have been
correctly added.
A GenTL application will attempt to connect
to these cameras, so if a camera is removed
from a system or moved to another port,
select the camera and click Delete.
9