Aircommand IBIS Panduan Petunjuk Pemasangan & Pengoperasian - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan & Pengoperasian untuk Pendingin Udara Aircommand IBIS. Aircommand IBIS 15 halaman.
Halaman Cetak
4. POSITION IBIS ON ROOF
- Remove the air conditioner from the
carton.
- Position the unit over the gasket so that
the corners of the square hole in the
caravan roof line up with the corners of
the square hole underneath the IBIS
(Fig 6).
TIP: Have one person inside the vehicle
looking through the hole while the other
is on the roof adjusting the position of the
unit
The unit weights approximately
50kg. Ensure a two person lift or
use a mechanical hoist to avoid
the risk of injury.
- DO NOT slide the unit on the roof, this
may damage the gasket and result in
leaks
- Four M8 mounting holes on the chassis
underneath the air conditioner will line
up with the corners of the square roof
hole (Fig 7).
5. CONNECT ELECTRICAL SUPPLY
- This unit MUST be installed in
accordance with State and National
Wiring regulations and in particular
AS3001 – 2008
- Refer to wiring diagram (Fig 9). Refer Fig
8 for position of terminal block
- Connect electrical supply to terminal
strip. Note position of active, neutral and
ground wires (Fig 9)
WARNING
Ensure that power is properly
disconnected at the supply (mains
and/or battery). Failure to do so may
result in damage to the unit and personal
injury or death.
- When connecting wires into terminal
strip apply suitable clamping pressure to
ensure wire is secure while taking care
not to over tighten and damage the
exposed wire ends.
Fig 6: Position the IBIS over the roof gasket and set it down gently
Fig 7: Shows the view from under the roof
Position the IBIS so the 4 mounting holes (circled) line up with the corners
Fig 8: Highlights the position of the terminal strip underneath the unit
Fig 9: Shows the positioning of the electrical wires into the terminal strip