hi-Fun hi-Call Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori Telepon hi-Fun hi-Call. hi-Fun hi-Call 19 halaman. Glove handset

mobile phone or other Bluetooth compatible devices, within 2

minutes. If during this time lapse hi-Call is not paired to any device

it turns off automatically. As soon as the device is paired the

indication LED (2) flashes slowly in blue.

Now is possible to make and receive calls with hi-Call.

If hi-Call was previously paired to a different device, it can be

switched again in pairing mode in order to pair it to another

device. You need to un-pair hi-Call from the paired device (check on

the device userʼs manual). At first the LED (2) will start flashing in

blue for a few seconds and afterwards hi-Call will switch in pairing

mode, signalled by the LED (2), which will flash alternately red and

blue.

3) Switch off hi-Call.

To switch off hi-Call hold the power button (3) until the LED (2)

flashes twice in quick succession. Immediately will hi-Call turn itself

off.

Make and receive phone calls

If hi-Call is paired to a mobile phone, it is possible to make and

receive phone calls thanks to the microphone and the auricular

placed respectively on the little finger and on the thumb of the left

glove. The buttons which control hi-Call functions are placed on the

back side of the glove over the wrist.

1)Answer an incoming call.

To answer an incoming call press briefly the multifunction button

(1).

2) End a phone call.

To end a phone call press briefly the multifunction button (1) when

you want to end the call.

3) Reject an incoming call.

To reject an incoming call hold the multifunction button (1) for 2

second, then release it. The incoming call is rejected.

4) Activate voice dialing / voiceover / Siri.

When there are no calls in progress it is possible to activate voice

dialing / voiceover / Siri from your mobile phone using hi-Call.

To activate voice dialing / voiceover / Siri hold the multifunction

button (1) until you hear a tone from the speaker on the thumb of

your left glove, afterwards release the multifunction button (1);

when you hear the second tone you can pronounce the command.