6TL YAV90090 Manual - Halaman 15
Jelajahi secara online atau unduh pdf Manual untuk Gerbang 6TL YAV90090. 6TL YAV90090 18 halaman. Ethernet to can gateway
Halaman Cetak
7. On the Action page, select Allow the connection and then click next.
8. On the Name page, type a name and a description and then click Finish.
2.6.2 Establishing the connection
1. Connect the RJ-45 connector of the YAV90090 via a LAN cable, directly to the
computer.
2. Connect the CAN cable to power up the module.
Power supply input voltage
Current consumption at voltage input @+24VDC
3. Wait until the YAV90090 is ready (RUN led is blinking green).
4. To check if there is connection, open the command prompt and ping the YAV90090
IP address. For example: ping 192.168.18.55.
2.6.3 Prepare Phi6 Explorer
2.6.3.1 UDP Unicast connection
1. Locate
the
"C:\Users\Public\Documents\6TL".
2. Edit the "Phi6Config.ini" file. Add "//" fifth line and remove it from the sixth and
seventh line.
3. Write in the IP field your Default Gateway.
2.6.3.2 UDP Multicast connection
1. Locate
the
"C:\Users\Public\Documents\6TL".
2. Edit the "Phi6Config.ini" file. Add "//" fifth line and remove it from the sixth and
seventh line.
3. Write in the IP field your own IP address. And write in the IPMULTICAST field the
IP multicast group configured by the switches.
6TL
folder.
It
6TL
folder.
It
Ethernet to CAN Gateway YAV90090 620090E06
V
8
B
I
260
B
should
be
in
the
should
be
in
the
24
30
V
DC
85
72
mA
following
directory:
following
directory:
15