2gig Technologies Go!Control Panel Panduan Pengguna - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem Keamanan 2gig Technologies Go!Control Panel. 2gig Technologies Go!Control Panel 20 halaman.

Halaman Cetak

Go!Control Wireless Security System | User Guide

Quick Exit in Away Mode

A programmable option called Quick Exit

may be displayed on the Security screen

while the system is armed in the Away

mode. Tapping the Quick Exit button starts a

timer to allow someone to exit or enter

through a sensor‐protected door

programmed for delay without having to

disarm the entire system. When the delay

timer runs out, the system returns to the

normal Away mode.

TIP: If interior sensors are installed in the

system in certain areas, do not violate

those sensors when using the Quick Exit

feature in Away mode.

Auto Stay Mode

The system may have been programmed by

the installer for Auto Stay mode. If this

option is on and the system is armed in Away

mode, if an exit/entry delay sensor is not

triggered before the Exit Delay expires (no

one left the premises), the system

automatically arms in Stay mode instead of

Away mode.

NOTE: Quick options can be turned on

or off by your installer. Refer to

"Installer Programmed Options" on

page 41, to see which options have

been set for your system.

Arming to Away Mode

Use the Away mode to arm the system when

everyone will be leaving the home. The

Away mode normally has an Entry Delay so

someone with a user code can re‐enter

without causing an alarm. Interior and

perimeter sensors are armed in the Away

mode.

Close all sensor‐protected doors and

windows before arming.

Verify that the

Panel is lit green, indicating that the

system is ready to arm. The Security

button and Arm button on the display

will also be green when all perimeter

sensors are closed. If the

displayed on the status bar, an interior

sensor is open, be sure to close or

manually bypass the interior sensors or

an alarm will occur.

To arm the system quietly without

sounding any announcements, tap the

button before performing the next

steps:

•

At the Arming screen select the

Silent Exit check box

•

During the Exit Delay, tap Silence

At the Security screen, or the Menu

screen, tap Arm.

If there are any open perimeter door or

window sensors, the Bypass screen

appears. Close all the sensors displayed

or tap Bypass All to force bypass the

displayed sensors.

NOTE: Bypassed sensors do not trigger

an alarm.

To bypass sensors, enter a user code

unless the installer has set the system for

Quick Bypass.

On the Arming screen, the Entry Delay

check box option can be used with Away

mode.

•

The system can be armed without an

Entry Delay. All perimeter doors trigger

the alarm instantly. The system has to be

disarmed with a wireless key fob. To arm

with all exit/entry perimeter doors as

instant, un‐check the Entry Delay option

button.

button on the Control

icon is