7-BIT Wicher 500i Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Perangkat Keras Komputer 7-BIT Wicher 500i. 7-BIT Wicher 500i 6 halaman.

CAUTION!!!

Please take special care when installing the PCB board and connecting the signal cables. Incorrect installation may

result in the damage to the computer or the turbo card.

When Wicher 500i rev.2c card is properly installed, you can finally put it through its paces.

X2 jumper configuration

Properly connected signal cables.

Position 0 – ON / OFF turbo card

Position 1 – 25 MHz / 12 MHz

Position 2 – RAS13 ON / OFF

CAUTION

RAS13 enabled for two-sided memory

RAS13 disabled for single-sided memories