Hi-Par HP1000E Control Panduan Pengguna
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Unit Kontrol Hi-Par HP1000E Control. Hi-Par HP1000E Control 2 halaman. Controllable ballast
Halaman CetakInstallation Directions
2. Power Cord
3. Magnet Ring
1. Digital Ballast
4. Power Input
8. Connect
7. Dimming Knob
Link Cable
STATUS
LED
Output lock down
1 Flash
Output errors
2 Flash
Low input voltage
3 Flash
Over temperature
4 Flash
High input
5 Flash
Note: When the controller is connected the CONTROL indicator LED ashes 2 times every 2
seconds - indicating controller is functioning correctly. However, if the Connect Link Cable is
removed during operation the ballast will shut down after 3 minutes. When operating
ballast without a HI-PAR Control Station the CONTROL indicator LED will be o . Turn power
o and on to reset the ballast when either connecting or disconnecting the Control Station.
MAINS POWER
MIN
MAX
BOOST
1116
1185
100%
1016
1085
75%
761
830
60%
602
671
DE lamps ONLY
5. Rubber Feet
6. OUTPUT to
HPS or MH lamp
BOX CONTENT:
1 x 1000w Digital Ballast
1 x Power Cord
1 x Connect Link Cable
4 x Rubber Feet
1 x User Manual
LAMP POWER
MIN
MAX
BOOST
1066
1135
100%
966
1035
75%
716
785
60%
566
635
USER MANUAL
HP1000E Control for DE HPS and MH lamps
Data is based on operation of a standard double ended HPS/MH lamp.
Supply power is based on typical commercial 240V,50/60Hz.
Performance
Model
Max Input
THD
Model
Voltage
Power
(V)
(W)
HP1000E
240V
1185
<10%
Control
Maximum
Power
Working
Ignitor
Current
Factor
Voltage
Voltage
(A)
(COSθ)
(V)
(kV)
5.0
.97
215-265
4.0