Hi-Rely RAIDPac-II Panduan Pengoperasian - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Penyimpanan Hi-Rely RAIDPac-II. Hi-Rely RAIDPac-II 20 halaman. Removable backup hard drive

Halaman Cetak

Figure 6 - RAID Type Descriptions

8. Using HW RAID Manager

Figure 7 – HW RAID Manager Screen. RAID Information

*This section is not intended to fully cover the features of the JMicron HW RAID Manager, as this is

not High-Rely's software, but rather software from the chip set maker of the chip set used in the RP2.

So, we will cover some basics. But, since this software is not under the control of High-Rely, it is

subject to change without notice. As of this writing, the version of software was 0.09.69 (check by

clicking the (?) in the top right corner).

The HW RAID Manager program is a Windows only program. The HW RAID manager program will

allow you to see RP2's internal drives, change RAID configurations, check the event log, and set up

SMTP alerts for the error conditions you select for the various RAIDPacs. If a drive RP2 is rebuilding,

it can tell you the percentage of completion of the rebuild. You can also change the RAID rebuild

priority.

On the left hand side of the panel are two tabs, "Basic Mode" and "Advanced Mode" Clicking in these

will allow you to use the corresponding feature sets.

At this time, the HW RAID Manager runs only in the tray for Windows XP and Server 2003. For

Windows Vista, 7 and Server 2008 and Server 2008 R 2, it runs as a service (JMRAID Manager). This

can cause problems for XP and Server 2003 users as it will not be present to log events or email

messages of events unless the user HW RAID Manager was installed for is logged in.

There are other software utilities, tools and ways to make a program run as a service. Google the

phrase, "running a program as a service" for a list of methods which may work.