Active Vision SX-460 Manual

Jelajahi secara online atau unduh pdf Manual untuk DVR Active Vision SX-460. Active Vision SX-460 2 halaman. 4channel 120fps dvr

SX‐460 Remote Viewing Guide

This guide covers the necessary steps to view an SX‐460 Remotely

***Note:

This guide assumes your SX‐460 has already been configured for remote viewing, and is working properly

Requirements:

•

A computer with internet access and Internet Explorer 6.0 or Higher

•

The serial number of your DVR

•

This guide assumes you have already completed the Internet Explorer Security Setup Guide

•

This guide assumes your SX‐460 is up and running.

Setup:

1) Open up Internet Explorer on your PC.

2) Type the address of your DVR (either a domain name or IP address) so that it looks like this:

http://your‐dns‐name‐here:8000 or http://69.24.118.12:8000

3) You may notice an information bar at the top of internet explorer (below the address bar)

Please allow all Active‐X controls to load and have access to your system by clicking the information bar, and

clicking "Install" or "Allow"

4) Once the Active‐X control has been installed, you may need to refresh the page by pressing the "F5" key on your

keyboard.

5) Once the Active‐X control has loaded, Click the "Connect" button

6) A dialog box will pop up, click the "Extend Config" button.

7) Fill in your DVR serial number for "DVR CODE", you "User ID", "User PW",

and either your "SITE IP" or your "DOMAIN"

8) Click the "Connect" Button"

Congratulations!!! You are now remote viewing your SX‐460 DVR!

Please continue onto the next page for some remote viewing quick

tips