Gaggenau CG261210AU Petunjuk Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Kompor Gaggenau CG261210AU. Gaggenau CG261210AU 20 halaman.

Gaggenau CG261210AU Petunjuk Pengguna
Installation and connection
en
Installation of cooktop into the
kitchen bench
Side clearances: If the distance measured from the
periphery of the nearest burner to any vertical surface is
less than 200 mm, the surface shall be protected in
accordance with clauses 6.10.1.2 of AS/NZS 5601.1.
Make an appropriate size cut in the work surface.
Seal all work surfaces made of wood with special
sealer/glue to protect it against moisture damage.
Note: Wear protective gloves to fit the hob.
Depending on the model, the adhesive seal may be
factory-fitted. If this is the case, it should not be
removed under any circumstances, since the adhesive
seal prevents leaks. If the seal has not been factory-
fitted, apply it to the underside of the hob.
Fitting the appliance onto the kitchen unit:
1
Screw each one of the clips into the position
indicated so that they are free to rotate.
2
Insert the appliance evenly into the cut-out.
3
Turn the clips and tighten them fully.
The position of the clips depends on how thick the
work surface is.
Do not stick the hob onto the worktop with silicone.
8

Electrical connection

An electrical 10 amp socket needs to be within 1 m of
the hotplate to allow electrical connection. The socket
must remain accessible after installation of the
appliance.
Important notes:
This appliance is connected to the mains (240 VAC)
by means of the connecting lead which must be
fixed to the kitchen unit to prevent it from coming
into contact with hot parts of the cooktop (or an
oven installed underneath) and remain accessible
after installation of the cooktop.
When making this connection make sure that the
lead cannot come into contact with hot parts of the
cooktop.
This appliance must be earthed. When connecting
the cooktop ensure that the earth wire is connected
first and that all wires are connected to the correct
terminals.
Wiring diagram
A
Switch
B
Blue wire
C
Brown wire
D
Terminal
E
Ignition module