2gig Technologies Vario Panduan Pengguna Cepat - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengguna Cepat untuk Sistem Keamanan 2gig Technologies Vario. 2gig Technologies Vario 10 halaman. Voice module
Juga untuk 2gig Technologies Vario: Panduan Petunjuk Instalasi (6 halaman), Panduan Pemasangan Cepat (18 halaman)
Halaman Cetak
2GIG Vario Quick User Guide
Introduction
This quick start guide describes the main user operating procedures for the 2GIG Vario system. To view the full 2GIG Vario System User Guide, visit our
website at www.2gig.com.
Keypad Indication
The 2 GIG Vario System LCD keypad is the primary system interface and reports its status via its LCD icons, as described below.
On
Off
Slow Flash
Power
Rapid Flash
On
Off
Ready
Slow Flash
On
Off
Slow Flash
Arm
Rapid Flash
On
Off
Stay /Bypass
On
Tamper
Off
On
Off
Fire
Flashing
LCD Status Display
The LCD status display varies depending on the number of partitions in your system. If your system is defined with only one partition, the LCD displays the
partition name, time, and date. If your system has two or three partitions, the LCD displays the system name, date, time, and the status of each partition.
Status letters represent partition status, as follows:
A: Partition Armed
S: Partition Stay Armed
Copyright © 2016 Nortek Security & Control LLC
Keypad LCD Icons
System is operating properly from AC power, backup battery is good , and there are no troubles in the
system.
No power.
System is being programmed.
System trouble.
System is ready to be armed.
System is not ready to be armed.
System is ready to be armed while exit/entry zone is open.
System is armed in Full Arm or Stay Arm mode.
System is disarmed.
System is in Exit Delay.
Alarm condition.
System is in Stay Arm or Zone Bypass mode.
No bypass zones in the system.
Zone/keypad/external module has been tampered.
All Zones are operating normally.
Fire alarm.
Normal operation.
Fire Circuit problem.
N: Partition Not Ready
R: Partition Ready
L: Partition in Alarm
5