GREAT PLAINS 4000TM Manual Penyesuaian - Halaman 7

Jelajahi secara online atau unduh pdf Manual Penyesuaian untuk Peralatan Pertanian GREAT PLAINS 4000TM. GREAT PLAINS 4000TM 7 halaman.

Gauge Wheel Adjustment:

Note: The gauge wheels should be set in the field

position to be 1/2" to 1 1/2" off the ground.

1) Loosen the set screws (16) on each gauge wheel.

2) Turn the jack handle (17) to adjust the spindle

receiver. Adjusting the jack handle counterclockwise

will run the wheel closer to the ground while turning

the jack handle clockwise will cause the wheel to run

further away from the ground.

3) After adjusting the gauge wheel to the desired posi-

tion, re-tighten the set screws (16).

Rolling Reel Spring Adjustment:

The reel down pressure may be adjusted by removing

the pin (18) and then either pushing the handle (19)

forward to increase the spring pressure or by pulling

the handle backwards to decrease the spring pres-

sure. When the desired amount of spring pressure is

achieved, re-insert the pin.

to run little or no down pressure in wet conditions.

Hydraulic Rolling Reel Adjustment: (Option)

Reel down pressure can be adjusted on the move

depending on the desired results.

Using the gauge on the back of the machine:

0 = No pressure/transport position/wet conditions

1-5 = Ideal operating range

6 = Most pressure/extremely hard soil

Note: Running the rolling reel at 6 can raise the rear of

the machine out of the ground and can cause the

machine to be unlevel.

Note: It is recommended

7 of 7

49375

49376

49372

Document

#TLUS600C-0001B