ADEMCO Accord Petunjuk Pengguna - Halaman 4
Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Sistem Keamanan ADEMCO Accord. ADEMCO Accord 10 halaman.
Halaman Cetak
- 1. Table of Contents
- 2. Full Set [1]
- 3. Part Set [2]
- 4. Night Set [3]
- 5. Unsetting
- 6. Unsetting after or During an Alarm
- 7. Testing the System [5]
- 8. Reprogramming Codes [8]
- 9. Isolating Zones [6]
- 10. Chime Facility [9]
- 11. Viewing the Alarm Log [0]
- 12. Indicators and What They Mean
- 13. System Settings
- 14. System Limitations
Activate each zone in turn – with each zone
activation the zone LED lights and the keypad
emits two beeps.
To exit Test Mode, enter your User Code: the
keypad beeps twice and the strobe stops
flashing.
ZONE ISOLATION [6]
ZONE ISOLATION [6]
To manually isolate (by-pass) one or more
zones enter your User Code, press the 6
(Isolate) key and then press the zone numbers
that you wish to Isolate; then press the √ √ key .
To isolate zone 4 and 8 enter 1234 6 4 8.
The zone 4 and 8 LEDs on the keypad now
flash.
To delete all zones from the isolation list enter
your User Code, press the 6 (Isolate) key then
press the √ key.
Once zones have been isolated the system
may be set in the normal way. When the
system is next unset all zones will be un-
isolated. Fire and PA zones can not be
isolated.
CHANGING CODES [8]
CHANGING CODES [8]
The alarm system can have up to eight
separate user codes. User 1 is the Master
User of the system.
To change a code enter the code (or the
Master User Code), press 8 (Code), then the
user number (1—8) and then the new code.
For example to change the Master User Code
from the default (1234) to 7658:
1234 8 1 5678.
MASTER CODE is now 5678.
4