Dynabrade Mini-Raptor Vac 61100 Panduan Pengguna - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penyedot Debu Dynabrade Mini-Raptor Vac 61100. Dynabrade Mini-Raptor Vac 61100 14 halaman. Wet/dry vac commercial use 16 u.s. gallon 60.5 liter
Halaman CetakTHE BEST REMEDY IS TO ADD MOISTURE TO THE AIR
WITH A CONSOLE OR INSTALLED HUMIDIFIER.
Volts
Total length of cord in feet
25
120V
Ampere Rating
More
Not More
Than
Than
0
-
6
18
18
6
- 10
16
10
-
12
14
12
-
16
UNPACKING
Pull lid latches in an outward motion and remove tank
cover. Remove any accessories and literature that may
have been packed in the vacuum tank.
ASSEMBLY
CASTER SYSTEM
ASSEMBLY
(Not standard)
With Rear Wheel Dolly
You will find two casters (a), two large rear wheels (b),
one axle (c), tool rack (d), four screws, four metal flat
washers, and two hair pins (e). Assemble as follows:
a
c
e
1. Make sure the cord is disconnected from the
receptacle then remove the tank cover.
2. Turn tank upside down so bottom is facing up.
PROUDLY DESIGNED, ENGINEERED, AND BUILT IN AMERICA SINCE 1969
50
100
150
AWG
16
16
14
16
14
12
16
14
12
12
Not recommended
TABLE A
b
d
3. Place one hair pin in one end of
the axle. FIGURE 2.
FIGURE 2
4. Slide on one washer.
FIGURE 3.
FIGURE 3
5. Slide wheel onto axle next to
washer. FIGURE 4. Be sure flat
side of wheel hub is facing outward.
FIGURE 4
6. Slide on one washer. FIGURE
5.
FIGURE 5
7. Slide axle through holes provided
in tool rack. FIGURE 6.
FIGURE 6
8. Slide on one washer. Slide
remaining wheel, then washer onto
axle end. FIGURE 7.
FIGURE 7
9. Insert hair pin into the remaining hole in the axle to
hold wheel in place.
10. Install tool rack assembly onto
dolly (already installed on tank) by
placing large slot in tool rack over
rim on back of dolly. FIGURE 8.
Push tool rack onto dolly until the
bottom of tool rack is flush with
FIGURE 8
bottom of dolly. NOTE: It is normal
for tool rack to fit tightly onto dolly.
Dynabrade, Inc. 8989 Sheridan Drive
PAGE 6
|
Clarence, New York 14031
|
dynabrade.com