CEL MT3 Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Alat Listrik CEL MT3. CEL MT3 16 halaman. Multipro

Halaman Cetak

Before Starting Work

Sharp blades, heat buildup and flying debris are a

danger to user and bystanders. Use of suitable

protective clothing, gloves, footwear, eye and ear

protection as well as safe working practices can reduce

these risks.

Dusts from materials such as lead-

containing coatings, some wood types,

minerals and metal can be harmful to

one's health. Touching or breathing-in the

dusts can cause allergic reactions and/or

lead to respiratory infections of the user

or bystanders.

Fitting Tools

If required, remove an already

mounted tool/accessory.

Loosen the screw with the hex key

and remove the tool/accessory. Be

sure to clear any debris.

Mount a suitable tool/accessory in

such a manner on the tool holder that

the offset faces downward.

Turn the tool/accessory to a position

favourable for the respective job, and

allow it to engage into the cams of the

tool holder. 12 different positions are

possible, each offset by 30°. Fasten

the tool/accessory with Locking Bolt

and Washer. Tighten the bolt with Hex

key until the washer and bolt are flush

with the tool/accessory and firmly

fixed.

NOTE:

The AC17 adaptor washer is not required to fit CEL blades on CEL tools.

Certain dusts, such as oak or beech dust, are

considered as carcinogenic, especially in connection

with wood-treatment additives (chromate, wood

preservative). Materials containing asbestos may only

be worked by specialists.

- Use dust extraction whenever possible.

- Provide for good ventilation of the working place.

- It is recommended to wear a P2 filter class respirator.

Observe the relevant regulations in your country for the

materials to be worked

Do not cover the venting slots of the machine while

working, as this reduces the working life of the

machine.

This tool vibrates at very high frequency. Regular

breaks must be taken to reduce the chance of injury. At

the first sign of discomfort work should immediately

cease.

The sanding plates are fitted

with Velcro backing for quick

and easy fastening of sanding

sheets with Velcro adhesion.

Before attaching the sanding

sheet , free the Velcro backing

of the sanding plate from any

debris by tapping to enable

optimum adhesion.

Position the sanding sheet flush

alongside one edge of the

sanding plate, then lay the

sanding sheet onto the sanding

plate and press firmly.

To remove the sanding sheet,

grasp it at one of the tips and

pull it off from the sanding plate.

4.0

5.0