DYNACO SCA-80Q Panduan Perakitan - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Perakitan untuk Penguat DYNACO SCA-80Q. DYNACO SCA-80Q 15 halaman. C9 replacement
Juga untuk DYNACO SCA-80Q: Manual (12 halaman)

Halaman Cetak

1. Schematic
2. Figure 10-Schematic of C11 Replacement Electronically Regulated Power Supply for

Install the 24 Volt Regulator, TO-220 Package

The 24 volt regulator (P/N TL783), U1, comes in a TO-220 package that looks like this

(there may be some variation in the plastic molding):

Install it with a heat sink, 6-32x3/8" screw

, and a keps nut following Figure 4. The

captive lock washer side should face the solder side of the PCB. Bend the leads down to

fit through the three holes in the PCB. Adjust everything so that it fits well. Tighten the

hardware, then solder the 3 leads.

Figure 4-Front and Back views of Q6 mounted on heat sink

This is the longest screw in the kit, as the other four screws are 6-32x1/4".

Page 8 of 15