ADEMCO LYNXR Series Panduan Memulai Cepat - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Sistem Keamanan ADEMCO LYNXR Series. ADEMCO LYNXR Series 8 halaman.

Keypad Functions (when default programming is used)

Security Functions

Checking system status: STATUS (high level messages); press STATUS again for secondary messages.

To arm in STAY mode: Press and hold down STAY (or enter your code + STAY ) See note below.

To restart exit delay: STAY (applies only if system is armed in Stay mode and Quick Exit option has been enabled)

To arm in AWAY mode: Press and hold down AWAY (or enter your code + AWAY ) See note below.

To arm with NO DELAY: Press and hold down AWAY or STAY + NO DELAY or enter your user code + the keys shown).

To disarm the system and silence alarms: User Code + OFF See note below.

To bypass a zone(s): User Code + BYPASS + 2-digit zone number(s)

To turn Chime mode on or off: FUNCTION + CHIME

Message Center

To record a message: FUNCTION + RECORD

To stop recording before end of 20 seconds: OFF

To play back a message: FUNCTION + PLAY

Volume Control

To adjust message playback/system announcement volume: FUNCTION + VOLUME + [3] (Up) or [6] (Down)

To mute system announcements: FUNCTION + VOLUME + OFF

To restore/unmute announcements & volume: FUNCTION + VOLUME + [3] or [6]

Note: If the system was muted during Field Programming it will be unmated upon exiting.

Other Functions

To set the time and date: User Code + FUNCTION + [63]

To activate or deactivate devices 1-6: FUNCTION + LIGHTS ON or LIGHTS OFF + device number

To activate or deactivate devices 7 & 8: User Code + # + LIGHTS ON or LIGHTS OFF + dev. no.

To program scheduled events: User Code + FUNCTION + [64], then follow procedure in User Manual.

To add a User Code: Master Code + CODE + user number + User's Code (see note below)

To delete a User Code (except Master Code): Master Code + CODE + user number

To turn Test mode on: User Code + TEST

To turn Test mode off: User Code + OFF

To use the defined AUX function: Press and hold AUX key 2 secs (4 beeps) + User Code

(To define the AUX function, refer to the procedure in the Aux Function section of the User Manual. Note: The 1-button paging

feature [field *87] is not enabled with the default programming)

-6-