ADEMCO LYNXR24 Panduan Memulai Cepat - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Sistem Keamanan ADEMCO LYNXR24. ADEMCO LYNXR24 8 halaman.
Juga untuk ADEMCO LYNXR24: Panduan Memulai Cepat (8 halaman)
Halaman Cetak
Keypad Functions (when default programming is used)
Security Functions
Checking system status: STATUS (high level messages); press STATUS again for secondary messages.
To arm in STAY mode: Press and hold down STAY (or enter your code + STAY ) See note below.
To restart exit delay: STAY (applies only if system is armed in Stay mode)
To arm in AWAY mode: Press and hold down AWAY (or enter your code + AWAY ) See note below.
To arm with NO DELAY: Press and hold down AWAY or STAY + NO DELAY or enter your user code + the keys shown).
To disarm the system and silence alarms: User Code + OFF See note below.
To bypass a zone(s): User Code + BYPASS + 2-digit zone number(s)
To turn Chime mode on or off: FUNCTION + CHIME
Message Center
To record a message: FUNCTION + RECORD
To stop recording before end of 20 seconds: OFF
To play back a message: FUNCTION + PLAY
Volume Control
To adjust message playback/system announcement volume: FUNCTION + VOLUME + [3] (Up) or [6] (Down)
To mute system announcements: FUNCTION + VOLUME + OFF
To restore announcement sounding: FUNCTION + VOLUME + [3] or [6]
Other Functions
To set the time and date: User Code + FUNCTION + [63]
To activate or deactivate devices 1-6: FUNCTION + LIGHTS ON or LIGHTS OFF + device number
To activate or deactivate devices 7 & 8: User Code + # + LIGHTS ON or LIGHTS OFF + dev. no.
To program scheduled events: User Code + FUNCTION + [64], then follow procedure in User Manual.
To add a User Code: Master Code + CODE + user number + User's Code (see note below)
To delete a User Code (except Master Code): Master Code + CODE
To turn Test mode on: User Code + TEST
To turn Test mode off: User Code + OFF
To use the defined AUX function: Press and hold AUX key 2 secs (4 beeps) + User Code
(To define the AUX function, refer to the procedure in the Aux Function section of the User Manual. Note: The 1-button paging
feature [field *87] is not enabled with the default programming)
Note: The Babysitter Code and Installer Code cannot disarm the system unless it was the code used to arm the system. In
addition, if the system is armed by pressing and holding the Quick-Arm buttons, neither the Babysitter Code nor the
Installer Code can disarm the system.
REFER TO THE INSTALLATION AND SETUP GUIDE FOR THE LIMITATIONS OF THIS SYSTEM AND
WARRANTY INFORMATION.
+ user number
-6-