GREAT PLANES Dazzler ARF Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mainan GREAT PLANES Dazzler ARF. GREAT PLANES Dazzler ARF 20 halaman.

WING ASSEMBLY

1. Locate the left and right Wing Panel and Wing Joiner.

Test fit the two wing halves to the wing joiner. Once you are

satisfied with the fit, glue the wing joiner into the right wing

panel with 6-minute epoxy. Set it aside to cure. Note: Be sure

to remove any epoxy that squeezes out before it cures.

2. After the glue has cured, apply 6-minute epoxy to the

other end of the joiner and the root ribs. Press the two wing

halves together. Use masking tape to hold the two wings

together while the glue cures.

3. After the glue has cured apply the self adhesive wing

tape to the wing joint.

1. Trim away the covering on the wing saddle.

2. Locate six triangle wood blocks. Glue them in place

on the inside of the fuselage flush with the wing saddle in the

locations shown in the photograph. (These blocks provide

additional surface area when we glue the wing to the

fuselage. Placement is not critical as long as three are

placed on each side) .

3. Place masking tape on the fuselage, one piece ahead

of the wing saddle and one piece behind the wing saddle.

Make a mark on each piece of tape exactly at the center of

the fuselage.