GREAT PLANES Douglas DC-3 Buku Petunjuk - Halaman 15

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mainan GREAT PLANES Douglas DC-3. GREAT PLANES Douglas DC-3 20 halaman.

3. Using two fiberglass hatch strips and medium CA, glue

two of the strips onto the sides of the hatch as shown in the

photo. Note that the strips have been trimmed so that they

are 1/4" from the edges of the hatch. Be sure to sand the

areas to be glued and clean them with a paper towel and

rubbing alcohol.

4. Using two fiberglass hatch strips and medium CA, glue

two of the strips onto the fuselage as shown in the photo.

5. The hatch is installed in the fuselage by squeezing the

sides and catching the side strips along the sides of the

fuselage opening. The two strips glued onto the fuselage

maintain the curvature of the hatch while the two pieces on

the hatch hold it in the opening. When complete the hatch

should fit evenly and securely. Small pieces of clear tape can

also be used on the leading and trailing edge of the hatch to

hold it more securely.

6. Install the tail gear wire onto the fuselage using two

2.5mm x 9.5mm flanged Phillips head screws as shown in

the photo above. Drill 1/16" [1.6mm] pilot holes for the

screws. Harden the holes with thin CA.

7. Mount the 25mm tail wheel with a 2mm wheel collar

and set screw.

8. Finalize the installation of the radio system by

mounting the speed control and the mini-receiver in the

fuselage with hook and loop strips as shown in the photo

above. Plug the servos and speed control into the receiver.

Use a 6" [153mm] servo extension wire for the aileron servo.

9. Mount the switch through the fuselage side as shown

10. Route the receiver antenna through the fuselage side

or bottom using a strain relief. Secure the antenna at the

rear of the fuselage with a piece of clear tape.

Apply the Decals

1. Use scissors or a sharp hobby knife to cut the decals

from the sheet.

2. Be certain the model is clean and free from oily

fingerprints and dust. Prepare a dishpan or small bucket with

a mixture of liquid dish soap and warm water–about one

teaspoon of soap per gallon of water. Submerse the decal in

the soap and water and peel off the paper backing. Note: