GREAT PLANES ElectroStik ARF Buku Petunjuk - Halaman 10

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mainan GREAT PLANES ElectroStik ARF. GREAT PLANES ElectroStik ARF 20 halaman.

Install the Elevator & Rudder Pushrods & Servos

❏

1. Using the mounting grommets and eyelets supplied with

the servos, install the elevator and rudder servo into the fuse

with the servo output shafts toward the front of the fuselage

as shown. Drill a 1/16" [1.6mm] hole through each mounting

hole location. Secure them with the servo mounting screws

that came with the servos.

❏

2. Cut three arms from a four-armed servo arm for both

the rudder and elevator servo. Enlarge the third hole out from

the center of each remaining arm using a 5/64" [2mm] drill

bit. Use your radio system to center the servos and install the

servo arms perpendicular to the servo case as shown.

❏

3. Screw a nylon clevis with a silicone clevis retainer onto

the threaded end of each of the 36" [914.4mm] pushrods

until the threaded portion of the pushrod emerges from the

clevis as shown.

❏

4. Insert both of the 36" [914.4mm] pushrods through the

exit slots at the rear of the fuse. Connect both the elevator

and rudder pushrods to their control horns. Use the third-

from-the-inner hole in the control horn for both pushrods to

obtain the recommended throws. Slide the silicone clevis

keeper over the clevis.

❏

5. Position the rudder and elevator in the neutral position

and hold them in place with tape or small clamps. Mark on

the pushrods where the pushrods cross the outer holes in

the servo arms.