Aircraft in Miniature Limited TRANSPORT WINGS DC-10-30 KIT Petunjuk Manual - Halaman 9
Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Mainan Aircraft in Miniature Limited TRANSPORT WINGS DC-10-30 KIT. Aircraft in Miniature Limited TRANSPORT WINGS DC-10-30 KIT 20 halaman. 1:72 mixed-media kit of the dc-10-30 second generation jet airliner
Halaman Cetak
(10) NACA intakes and exhaust outlets.
(a) Decide is the exhaust outlet doors are to be open or closed.
(b) Cut out the holes for the components as shown in the
.
(11) Assemble the centre (tail) engine assembly.
1
If they are to be open, cut out the areas for the intakes
and the outlets.
2
If they are to be closed, use the scribing template and
scribe the outlines of the doors.
photograph below.
(1) Mark the position of each rectangle on the outside of a
fuselage half.
(2) Carefully cut out a rectangle of plastic. Make it
undersize and slowly increase the size of the cutout
until the resin part is a good fit. Do this for each resin
part.
(3) Remove plastic from inside the fuselage until the front
of the resin part is flush with the outer surface. If you
remove too much plastic, make packers from .005"
plasticard to give a good fit.
(4) When you are happy with the fit of all the parts, attach
them from the inside of each fuselage half.
2 - Remove plastic until
face is flush with
outside of vacform nose.
3 - Attach door with
5-minute epoxy
adhesive
1 - Cut out rectangle
from vacform nose
Door or intake