GREAT PLANES F4U Corsair Buku Petunjuk - Halaman 9

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mainan GREAT PLANES F4U Corsair. GREAT PLANES F4U Corsair 16 halaman. Arf plane

Elevator Installation

❏

1. Remove the battery hatch from the fuselage by pulling

straight up on the tab as shown. The hatch is held in place by

a magnet.

❏

2. Slide the elevator pushrod guide into the hole in the

rear of the fuselage as shown. Leave 1/4" [6mm] extending

out of the fuselage. Add a couple drops of thick, foam safe

CA to secure the tube in place.

❏

3. Install the elevator servo as shown. Be sure to remove

the servo arm prior to gluing the servo in place. Install a

quick connector in the outer hole on the servo arm and

reattach it to the servo.

❏

4. Insert the 20-3/4" [527mm] elevator pushrod wire

into the pushrod guide. When the wire enters the radio

compartment, guide it into the servo quick connector. Do

not tighten the quick connector yet.

❏

5. Align the elevator control horn with the pushrod as

shown. Align the holes in the control horn with the hinge

line. As before, cut a small slot in the elevator and install the

control horn as shown.