GREAT PLANES FW-190 Focke Wulf Buku Petunjuk - Halaman 8

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mainan GREAT PLANES FW-190 Focke Wulf. GREAT PLANES FW-190 Focke Wulf 20 halaman.

Install the Tail Surfaces

❏

1. Slide the stab into the slot in the rear of the fuselage.

Center it as you did with the wing. Make sure the

measurements shown in the sketches are equal. Glue the

stab in place when satisfied with the fit.

❏

2. Locate the 13.5" [343 mm] carbon elevator rod. Insert

this rod into the preinstalled plastic bearings on the stab. DO

NOT glue in place.

❏

3. Use foam-safe CA to glue one of the elevator halves

to the carbon elevator rod. Then glue the other elevator to

the carbon rod. Be sure the two halves are even as shown.

❏

4. Glue the fin and rudder to the fuselage with epoxy.

Make sure that the fin remains perpendicular to the stab and

centered on the fuselage.

❏ ❏

1. Locate one of the carbon wing hinge assemblies.

One of the carbon tubes is glued to the bearings; the other

is free to rotate. Remove the loose carbon tube to prevent

accidental gluing in the next steps.

❏ ❏

2. Test fit one of the wing hinges in the wing. The outer

bearing should be flush with the wing tip. When satisfied with

the fit, epoxy the hinge in place. Be careful to avoid getting

epoxy into the open bearings.