GREAT PLANES Spectra Buku Petunjuk - Halaman 10

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mainan GREAT PLANES Spectra. GREAT PLANES Spectra 16 halaman.

Folding Propeller Installation

1. Install the blades onto the folding propeller's hub using

the steel pins supplied. Install the socket head set screw

provided in the folding propeller's hub. This set screw will be

used to tighten the folding propeller to the motor's shaft.

2. Install the spinner onto the folding propeller's hub using

the bolts provided as shown above

3. Install the folding prop onto the motor's shaft and

tighten the hub's set screw.

Final Hookups & Checks

1. The canopy is held in place with a rubber band. Loop a

medium size rubber band through the cut-out in the rear

canopy brace. Thread the rubber band through itself and then

hook it on the little extension on the fuselage former.To remove

the canopy, pick up on the back until the dowel is clear of the

fuselage. To reinstall the canopy just do the opposite.

2. Trim the covering at the bottom of the airplane to open

the outlet holes. This will allow the cooling air for the motor

and motor battery to exit the fuselage.

Note: A piece of self-adhesive foam rubber weather stripping

(not included) can be applied to the front of the fuselage

bottom to help protect it from getting nicked up during landings.

Use the sketch to make sure the control surfaces are

moving the correct directions.