Automate AM2 Panduan Instalasi - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Kontrol Jarak Jauh Automate AM2. Automate AM2 18 halaman.
Juga untuk Automate AM2: Panduan Pemilik (19 halaman)

Halaman Cetak

11 SECURITY FEATURES: When selected O O F F F F , the (-) ground-when-armed and ignition sense

trigger will not be active upon locking the vehicle. When selected ON, (-) ground-when-armed

output will be active and can be used to operate a starter kill. The unit will also trigger a panic

sequence if the ignition is turned on before unlocking/disarming the system.

12 CODE HOPPING O O N N /OFF: The system uses a mathematical formula to change its code each

time the transmitter and receiver communicate. This makes the group of bits or "word" from the

transmitter very long. The longer the word is, the easier it is to block its transmission to the unit.

Disabling the Code Hopping

feature lets the receiver ignore the Code Hopping

part of the trans-

mitted word. As a result, the unit may have better range with Code Hopping

off.

13 2ND UNLOCK OUTPUT O O F F F F /ON: When selected OFF, the H1/2 blue wire has no function.

This feature is defaulted off to allow the user to be able to press unlock on the (4-Button) to unlock

the car no matter what state the vehicle in. When using a (3-Button) single lock/unlock button it

will just toggle back and forth between lock and unlock. When selected ON, pressing unlock twice

on the remote will output a negative pulse on the H 1/2 blue wire.

14 Comfort closure OFF/CC1/CC2: The system can be programmed to close the windows when

the system is armed. When CC1 is selected, a 20-second output starts 200ms after the last lock

pulse. When CC2 is selected, a 20-second output starts immediately after the lock pulse. NOTE:

CC2 was designed for some vehicles that may panic the factory alarm when set in the CC1 setting.

15 Aux relay control (DOMELIGHT SUPERVISION/Aux Channel 2): When selected to

domelight supervision and feature 7 is turned on, the dome light will turn on for 30 seconds every

time the ignition is turned off and upon unlock/disarm. When selected to Aux Channel 2, the

onboard domelight supervision relay is converted into a high current Aux channel 2 and in return

the red/white H 1/18 wire is converted to a 200mA (-) domelight supervision output.

Transmitter/Receiver Learn Routine

The system comes with two transmitters that have been taught to the receiver. The receiver can store

up to four different transmitter codes in memory. Use the following learn routine to add trans-

mitters to the system or to change button assignments if desired.

K K e e y y . . Turn the key to the ON position.

2007

Directed Electronics