GREAT PLANES Tori Buku Petunjuk - Halaman 15

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pesawat terbang GREAT PLANES Tori. GREAT PLANES Tori 20 halaman.

❏

7. Cut a strip of the rougher, hook side of the included

adhesive-back hook-and-loop strip to a length of 3-3/8"

[85mm] and apply to the top of the battery plate with CA glue.

❏

8. Roughen the bottom of the fuselage in the area of

the battery plate. Then, use medium CA to glue the battery

plate into position so the aft edge will be approximately 1/2"

[13mm] from the former at the wing LE.

❏

9. Determine whether you will shorten the wires on

your ESC, or leave the ESC wires as-is. The ESC may be

installed as supplied with the long motor wires, but removal

and installation of the battery will be easier without excess

wire in the way. Follow these instructions to shorten the

ESC wires:

A. Cut the motor wires to the desired length – about 1/2"

[13mm] is fi ne.

B. Strip approximately 1/8" [3mm] of the insulation from

the end of the wires and tin the exposed wire.

C. Cut and remove the shrink tubing from the bullet

connectors on the cut off ESC wires. Then, unsolder the

three bullets from the old wires.

D. Re-solder the bullets to the shortened wires on the ESC.