Dynacord COBRA Buku Panduan Pengguna - Halaman 9
Jelajahi secara online atau unduh pdf Buku Panduan Pengguna untuk Sistem Pembicara Dynacord COBRA. Dynacord COBRA 16 halaman. Compact line array systems
Halaman Cetak
- 1. Table of Contents
- 2. General
- 3. Cobra System / Cobra-4 System
- 4. Setting up
- 5. Tips on Setting up
- 6. Aiming
- 7. Cobra System Configurations ( Sub / Pwh )
- 8. Cobra-4 System Configuration ( Top / Pwh )
- 9. Cobra-4 System ( Basic Set )
- 10. Cobra-4 Expansion
- 11. Cobra System Amp Racks
- 12. Flying Accessories
- 13. Cobra System Country Specific Versions
- 14. Technical Specifications
7. CONFIGURATIONS COBRA-SYSTEM ( PWH / TOP )
The following illustrations show the basic set of an active 2-way COBRA SYSTEM with the planar waveguide
bass horns COBRA PWH as well as various possible arrangements.
The COBRA SYSTEM illustrated below with 4 x COBRA TOPs and 4 x COBRA PWH bass horns generates
a maximum SPL of 137 dB L + 137 Db R in the mid/high frequency range and up to 144 dB in the low
frequency range.
COBRA-SYSTEM
DSP244
L 2400
L 2400
INPUT A
TOP/SUB
N.C.
CP-44
N.C.
TOP/SUB
INPUT B
A
A
B
B
RS-485
IN
OUT
COBRA-SYSTEM
maximum sensible expansion variation
The "long throw" and "wide" configurations described in Chapter 6 hold good for all types of tops and bass
enclosures. Tops are arranged in a horizontally angled configuration where the need is for particularly
wide coverage (stage at the long-side) or stacked vertically when the need is for coverage over long
distances (stage at the narrow side).
Bass enclosures are arranged centrally in front of the stage (as a bass cluster) when maximum almost
omni-directional sound pressure level is called for.
With the typical L / R arrangement alongside the stage, the width should not exceed 6 to 8 metres to avoid
destructive interference (or 'cancelling') in the area in front of the PA as a result of path length differences. If
wider arrangements > 10 metres are called for, it is preferable to spread the bass enclosures along the entire
width of the stage to form a horizontal bass array. With this configuration, maximum projection and a more
even distribution of the low frequency range across the entire width of the audience area is achieved without
pronounced cancellation due to path length differences to the various bass enclosures.
EXTENSION : 2x COBRA-TOP
COBRA-SYSTEM
BASIC-SET - 2
4x COBRA-TOP
4x COBRA-PWH
1x CSW 25 2,5°
1x CSR-12
DSP244
L 2400
L 2400
INPUT A
TOP/SUB N.C.
CP-44
N.C.
TOP/SUB
INPUT B
A
A
B
B
RS-485
IN
OUT
EXTENSION 2x COBRA-PWH
Basic set and expansion possibilities
COBRA-SYSTEM
EXTENSION - 2
( 2x BASIC-SET 2 )
8x COBRA-TOP
8x COBRA-PWH
2x CSW 25 2,5°
2x CSR-12
DSP244
L 2400
L 2400
CP-44
INPUT A
TOP/SUB
N.C.
N.C.
B
TOP/SUB
INPUT B
A
A
B
IN
RS-485
OUT
COBRA SYSTEM with COBRA PWH
For
reaching bass reproduction of a wide
variety of styles of music, COBRA
PWH bass horns can be integrated into
the COBRA SYSTEM.
Two floor-standing COBRA PWHs
stacked one on top of the other raise
the COBRA TOPs to the required level
above the heads of the first few rows of
the audience.
Grooves on the top and sides of the
enclosures
different arrangements and ensure
absolute stability when stacking the
enclosures.
Depending
configuration, two 8-pin and two 4-pin
IN/OUT sockets allow the system to be
connected up in active 2-way COBRA
SYSTEM (4-pole) and active 4-way
COBRA-4 SYSTEM (8-pole) modes
using only one system cable per stack.
A maximum of 6 COBRA TOPs and 6
COBRA PWHs can be driven from the
CSR-12 amp rack.
The mixing of COBRA SUB and
COBRA PWH enclosures is also
possible, although optimal results are
obtained with bass enclosures of the
EXTENSION
same type in conjunction with the
4x COBRA-PWH
appropriate preset of the DSP 244
controller.
especially
powerful
permit
a
multitude
upon
the
and
far-
of
panel