Automated Pet Care Products LITTER-ROBOT Manual - Halaman 13

Jelajahi secara online atau unduh pdf Manual untuk Produk Perawatan Hewan Peliharaan Automated Pet Care Products LITTER-ROBOT. Automated Pet Care Products LITTER-ROBOT 18 halaman. Self-cleaning litter box
Juga untuk Automated Pet Care Products LITTER-ROBOT: Manual (16 halaman), Panduan Pengguna (19 halaman)

Halaman Cetak

Automated Pet Care Products, Inc.

Troubleshooting

1. Lights on the Control Panel are blinking once per

second

If the Globe cannot find the home position, all

three lights on the Control Panel will blink at a

rate of once per second. Make sure the Litter-

Robot is on a level surface. If the condition

persists, please call Customer Service.

2. Red light on the Control Panel is flashing

If the Cat Sensor setting is too sensitive, or if

the switch is dirty, the red light on the Control

Panel will flash at a rate of once per second.

The Globe will not rotate until the Cat Sensor

sensitivity is set properly, or the switch has been

cleaned. Before adjusting the sensitivity, make

sure that you do not have too much litter in the

Globe. The maximum litter level is 2" below the

bottom rim of the cat's entrance opening.

To adjust the Cat Sensor sensitivity, see the

section "Adjusting the Cat Sensor" in this

manual.

To clean the Cat Sensor, follow the next steps.

40 W. Howard, Suite B-5, Pontiac, MI 48342

Toll Free: 877-250-7729 Fax: 248-253-1797

www.Litter-Robot.com

Automated Pet Care Products, Inc.

Locate the Cat Sensor switch directly under the waste

drawer at the front of the Base.

After cleaning, press any of the three buttons on the

Control Panel to cancel the flashing red light. If the red

light continues to flash, call Customer Service for

assistance.

40 W. Howard, Suite B-5, Pontiac, MI 48342

Toll Free: 877-250-7729 Fax: 248-253-1797

www.Litter-Robot.com

Push down on the Base

to separate the contacts

of the switch. Check for

contamination or litter

trapped between the

contacts.

With the switch held

open (by holding down

on the front of the

Base), spray some

WD40 between the

contacts.